www.policetees.com

• POWERDECAL comes with batteries and window mounting clips set in place; clips use quality 3M VHB adhesion strips. Package includes one extra set of window clips.
  
  BEFORE INSTALLATION:
  
  Use rubbing alcohol pad included in package to prepare window surface, alcohol pad will remove carwash window cleaner residue. Surface needs to be completely dry for proper 3M VHB adhesion.
  
  INSTALLATION:
  
  Step 1: Remove TRY-ME button and strip (pull out firmly).
  
  Step 2: Peel red tabs to expose glue strips. (Helpful tip before mounting to glass, have someone stand outside and comment when positioned correctly from on looker’s view point.)
  
  Step 3: Position on glass and press firmly for 30 seconds. Then, using your thumbs, press against both clips for an additional 30 seconds for better results. (Works best on flat area of glass.)
  
  Step 4: Set switch to ON position.
  
  
  •     Must mount to window surface in temperature range of 50 to 80 degrees F.
  •     Position onto flat area of window for mounting clips to function best.
  •     Always leave 1 in. of clearance for device to slide up and out of window clips.
  •     Do not use on retracting or sliding windows.
  
  
  ALWAYS:
  
  Check local and state vehicle laws before installation and product usage.
  
  BATTERIES:
  
  Device uses three standard Alkaline AA batteries (included).
  
  Changing Batteries:
  
  Step 1: Lift device up and off window clips.
  
  Step 2: Remove battery door and install new batteries; align + and - orientation.
  
  Always dispose of old batteries properly.
  

Frequently Asked Questions

Q. I set switch to ON position and POWERDECAL doesn't light up immediately, why?
A. POWERDECAL is designed to only light up in darkness while driving (detecting vehicle motion).

Q. How does it turn ON automatically?
A. POWERDECAL has multiple sensor technologies so it first senses for darkness and then for vehicle motion. Device will light up only when both conditions are prevalent.

Q. Can I test it before vehicle installation?
A. Yes, first remove Try-Me strip (pulling out firmly) and set switch to ON position. Test by placing device in dark environment (example: desk drawer), then rattle desk drawer to simulate movement. Open drawer; POWERDECAL should be lighted. Make sure switch is set to ON position. 

Q. Do I have to turn POWERDECAL OFF?
A. No, once parked POWERDECAL will shut OFF automatically after 2 minutes.

Q. How does it turn OFF automatically?
A. POWERDECAL senses non-movement then it shuts off after 2 minutes.

Q. Why do I need the OFF position?
A. If for some reason you do not want the decal to light up while driving at night, you may shut device off.

Q. WINDOW CLIPS: why do I have an extra set of window clips?
A. This is to make sure you can reinstall if you do not like original window placement.

Q. WINDOW CLIPS: why don't my clips stick to window surface?
A. Window must be 100% clean (use rubbing alcohol to remove grease) and 100% dry before pressing window clips onto window surface (see #2 under Trouble Shooting, scroll down).

Q. WINDOW CLIPS: can I re-stick the clip back onto a window once used?
A. No, for best result always use new window clips for mounting.